Description

Quadex Hyperform is a one component, rapid-setting, high early strength patching material designed for repairing vertical and horizontal concrete and masonry structures.

Recommended For

  • Filling large voids in manhole walls.
  • Reconstructing inverts.
  • Catch basin and concrete.
  • Pipe Repair

Features & Benefits

  • Rapid-setting
  • High Early and ultimate strengths
  • Non-shrinking
  • No calcium chloride
  • Ready to use – just add water
  • Excellent resistance to freeze-thaw

Typical Performance Data

Compression Strength PSI (ASTM C109)
30 minutes     >1,200 psi
1 hour     >2,500 psi
1 day     >4,000 psi

Bond Strength (ASTM C882)
28 day     >3,000 psi

Packaging

Quadex Hyperform is supplied in 60 lb. (927 KG.) poly-lined bags.

Yield

Quadex Hyperform will yield approximately .50 cu. ft. (787 cu. in.)

Application Information

Prepare surface to be patched by removing all loose concrete by using an air or electric hammer. Next, sandblast or water blast surface to clean away all contaminants, such as oil, chemicals, or dust. Then air blast with oil free compressed air to remove all wear or loose sand.

Mix Quadex Hypeform with clean potable wear at a rae of 1.4 gallons per 60 pound bag. If needed, Hyperform can be extended with 3/8″ aggregate at a rate of 25 pounds per bag.

Warranty

Quadex warrants its products to be free of defects in material and workmanship. Quadex will replace any product proved to be defective when applied in accordance with manufacturer’s instructions. Quadex’s obligation shall be limited solely to such replacement. There are no other warranties by Quadex expressed or implied.

Precautions

Avoid eye contact or prolonged contact with skin. Wash thoroughly after use. Persons using Quadex Hyperform should wear necessary eye protection, dust mask and rubber gloves. Read all product labels and technical literature.